Heat and Seal Adhesive - Stiff

Heat and Seal will be your answer for smaller runs of patches, emblems, and badges. This film will be attached to the backside of a finished embroidered image.

All edges will be nicely sealed. The finished edge will not look quite like a patch that has gone through a 'merrowing' machine but will stay together and be the best you can produce in smaller quantities from start to finish.
Heat and Seal can then give the end-user the choice to iron-on or heat-press the patch to the garment(textile) or become a 'sewn-on' patch. A hook-n-loop type attachment is also a viable choice.

Comes as a roll, 19" wide by 10 yards long. Also available in one-yard sheets and a 100-yard roll.
Product thickness: 7mil

To bond Heat and Seal to the back of the emblem/patch material:
320-330 degrees / 40-50 psi / 10 seconds press time/flip  and press again

To bond patch to garment:
320-330 degrees / 60-80 psi / 10-15 seconds press time on the front side/flip and press from the back side 20-25 seconds


Extra information